Difference between revisions of "Xtensa"

From Free Pascal wiki
(Preparations)
Line 1: Line 1:
----
+
{{Warning | The ESP32 support is highly experimental and prone to be broken. This description is work in progress.}}
Note: the ESP32 support is highly experimental and prone to be broken. This description is work in progress.
 
----
 
  
 
= Building FPC =
 
= Building FPC =
Line 32: Line 30:
 
Monitor the output with:
 
Monitor the output with:
 
   idf_monitor.py  --port /dev/ttyUSB0 hello.elf
 
   idf_monitor.py  --port /dev/ttyUSB0 hello.elf
 +
 +
 +
[[Category:Embedded]]

Revision as of 08:30, 7 April 2020

Warning-icon.png

Warning: The ESP32 support is highly experimental and prone to be broken. This description is work in progress.

Building FPC

Preparations


So far Linux only


Install esp-idf and execute

source ~/eps/esp-idf/export.sh

to get the pathes and environment set (namely tools path and $IDF_PATH are needed)

Change into the fpc directory and run

 make FPC=fpc CPU_TARGET=xtensa OS_TARGET=freertos "CROSSOPT=-Cplx6 -XPxtensa-esp32-elf- -Cfhard" all

to get ppcrossxtensa .

Create a hello world program in the fpc dir and compile it with

 compiler/ppcrossxtensa -Furtl/units/xtensa-freertos/ -Tfreertos -Cawindowed -XPxtensa-esp32-elf- -O3 -Wpesp32 -Fl~/xtensa-esp32-elf-libs  -Fl$HOME/.espressif/tools/xtensa-esp32-elf/esp-2019r2-8.2.0/xtensa-esp32-elf/xtensa-esp32-elf/lib/ hello

Get partition-table.bin and bootloader.bin from the hello_world example compiled above and copy them into the same dir as the compiled hello.bin

Flash with

 esptool.py -p /dev/ttyUSB0 -b 460800 --before default_reset --after hard_reset --chip esp32  write_flash --flash_mode dio --flash_size detect --flash_freq 40m 0x1000 bootloader.bin 0x8000 partition-table.bin 0x10000 hello.bin

Monitor the output with:

 idf_monitor.py  --port /dev/ttyUSB0 hello.elf