ARM Embedded Tutorial - Raspberry Pi Pico saying Hello via UART
Next peripheral on the list is the UART.
You will now start to find a pattern, we add some objectfiles, implement a few dependencies that were defined as inline in the C-Code and in the end we have our app that outputs test via UART0 to the Pins 0+1 of the Pico:
program Blinky; {$L gpio.c.obj} {$L uart.c.obj} {$L clocks.c.obj} {$L xosc.c.obj} {$L pll.c.obj} {$L watchdog.c.obj} {$L platform.c.obj} {$LinkLib gcc,static} procedure clocks_init; external; procedure gpio_init(gpio : longWord); external; procedure gpio_set_function(gpio:longWord;fn:longWord); external; function uart_init(var uart : TUART_Registers; baudrate:longWord) : longWord; external; function uart_is_writable(var uart : TUART_Registers):boolean; begin result := (uart.fr and (1 shl 5)) = 0; end; procedure uart_puts(var uart : TUART_Registers; const s : string); var i : longWord; begin for i := 1 to length(s) do begin repeat until uart_is_writable(uart); uart.dr := longWord(s[i]); end; end; procedure runtime_init; const RESETS_SAFE_BITS= %1111111111100110110111111; RESETS_PRECLOCK_BITS= %0001111000100110110111110; RESETS_POSTCLOCK_BITS=%1110000111000000000000001; begin resets.reset_set := RESETS_SAFE_BITS; resets.reset_clr := RESETS_PRECLOCK_BITS; repeat until (resets.reset_done and RESETS_PRECLOCK_BITS) = RESETS_PRECLOCK_BITS; clocks_init; resets.reset_clr := RESETS_POSTCLOCK_BITS; repeat until (resets.reset_done and RESETS_POSTCLOCK_BITS) = RESETS_POSTCLOCK_BITS; end; const BAUD_RATE=115200; UART_TX_PIN=0; UART_RX_PIN=1; GPIO_FUNC_UART=2; var i : longWord; begin runtime_init; uart_init(uart0, BAUD_RATE); gpio_set_function(UART_TX_PIN, GPIO_FUNC_UART); gpio_set_function(UART_RX_PIN, GPIO_FUNC_UART); repeat uart_puts(uart0, 'Hello, UART!'+#13+#10); for i := 0 to 300000 do ; until 1=0; end.
one notable change is that you may have seen that we do not provide __aeabi_uidiv anymore, instead we link to libgcc.a and get (hopefully) best possible performnce for the div....
This application is best tested with picoprobe, when you connect it to your development board as described in the Getting Started Guide chapter then the gpio pins 0 and 1 are connected to the debug probe which makes them visible as a serial interface on your computer.
Connect your terminal program to the UART port and enjoy the message from your pico...